Configuring RRC-1258 for Alinco DX-SR8, detached panel (mode=12)
(updated 2010-May-17)

Open your web browser and write the IP address corresponding to the RRC-1258MkII you want to configure. Click on the "Radio Settings" link to left. You will now see a new web page where the existing parameter settings is shown. Edit the parameters you need to change and then click on "submit". The new settings will now be save  in the non volatile memory. When you have done all changes need on the different pages the click on the "Apply Changes " button and the RRC will restart with the new settings in place. Down below is the parameters which is important for the TS-480 described. For the other parameters check the "Common configs" page.

 

Program mode	= 12 - DX-SR8 for Alinco DX-SR8
Control panel	Always = 1 at Control-RRC ( not available in the RRC-1258MkII )
Sip password	Protect your rig. Should be same in both ends. ( default is no password set)
Sip Contact	Sets the IP or DynDNS name to the radio QTH.
Auto connect	No functionality for DX-SR8
Audio Quality	Sets the audio quality depending on available bandwidth ( default = 2)
Codec out gain	Always 255 255 is no attenuation 254 = 0,5 dB attenuation eg 0,5 dB/step
Codec input gain	Should always be 12 at Control-RRC for DX-SR8 0 = 0 db gain increasing 0,75 dB/step 12 = 9,0 dB
Codec inp preamp	Switch the 20 dB Codec Preamp ON/OFF, only available at Control RRC Normaly On (except for not modified RCC with hardware version 4)
COM0 baudrate	Baud rate should 38400 for  DX-SR8.
COM0 data bits	Data bits should be 8 for  DX-SR8.
COM0 stop bits	Stop bits should 1 for  DX-SR8.
COM0 parity bits	Parity should be Off for  DX-SR8.

Configuration of the radio specific parameters  (Radio-RRC-1258MkII ) via internal web server

Open your web browser and write the IP address corresponding to the RRC-1258MkII you want to configure. Click on the "Radio Settings" link to left. You will now see a new web page where the existing parameter settings is shown. Edit the parameters you need to change and then click on "submit". The new settings will now be save  in the non volatile memory. When you have done all changes need on the different pages the click on the "Apply Changes " button and the RRC will restart with the new settings in place. Down below is the parameters which is important for the TS-480 described. For the other parameters check the "Common configs" page.