Microbit Setup Manager software
(update 10-03-16)

The initial settings of the network parameters like IP-number is easiest done via the Setup manager. The Microbit Setup Manager is a software which runs in your PC. The Manager connects to the RRC-1258, RRC-1258MkII and the Webswitch 1216H via USB. A USB cable is supplied with the RRC-1258MkII and the WebSwitch 1216H.

RRC-manager can be used for:
- Setting IP
      IP-adress
      Netmask
      Gateway
      DNS
      DHCP (on/off)
- Read IP (if DCHP is used it could be useful)
- Upgrade firmware
      Application
      Bootloader

Start with downloading the Microbit Setup Manager.

Download Microbit Setup Manager_v1.7             Minor fixes

Download Microbit Setup Manager_v1.6             Minor fixes

Download Microbit Setup Manager_v1.5             1 st. version for both RRC and the WebSwitch

Download RRC-Manager_v1.2             Needed from RRC-1258 v2.6

Download RRC-Manager_v1.1             Only minor updates

Download RRC-Manager_v1.0

Install the Setup Manager by following the instructions which shows up. If you have a older operating system installed where Netframework 2.0 is not installed, the installer will guide you trough the installation of the  Netframework