Remote Rig

RRC 1258 Support in English => General discussion forum => Topic started by: N8CL on 2020-02-09, 17:56:09

Title: CAT lost
Post by: N8CL on 2020-02-09, 17:56:09

About once a day, often at startup, I have no CAT: I can hear signals but frequency does not follow VFO.  This is cured by removing power (power connector and USB cable) from the Control RRC and re-powering.  The Radio side has no problems.  Any ideas for a cure??

Thanks, Chuck, N8CL

Title: Re: CAT lost
Post by: dj0qn on 2020-02-10, 01:40:28

Hi Chuck,

Your USB is going into power saving mode. Go to the following presentation at:
https://www.kkn.net/~n6tv/N6TV_Dayton_2019_Everything_USB.pdf
and follow the instructions starting on page 26.

73,
Mitch DJ0QN / K7DX

Title: Re: CAT lost
Post by: N8CL on 2020-02-10, 20:06:41

And here I thought I had checked the power settings many times--but I swapped out computers recently, and the new laptop had power save turned on.  Thanks for your help, Mitch.

73, Chuck, N8CL