Remote Rig

RRC 1258 Support in English => Configuration, RRC 1258 => Topic started by: ab7r on 2011-10-21, 22:17:53

Title: COM2 and VCOM port
Post by: ab7r on 2011-10-21, 22:17:53

If I want to use another radio (K3) at the control side connected to the RRC COM2 port can I also use the COM2 USB port for computer rig control/logging at the same time?  If not, how can it be done?

Thanks
Greg

Title: Re: COM2 and VCOM port
Post by: sm2o on 2011-10-23, 16:05:39

In the K3 Twin config you can use com-1 for logging in control end and com-1 for antenna switch for example in radio end. Com 1 is intelligent mixed with com 2 just for this purpose. Com-1 should the be set to mode 7 in both ends.

This is only available in the not yet relased firmware for Elecraft Twin

73 de mike