Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: Leo on 2012-05-02, 20:37:06
-
Hello!
I do not work with DSP filters work in the twin. FT DX-5000MP transceivers on both sides. I'm better handle width settings, but nothing happens. Wight changed only roofing filters.
What should I do to be able to control the DSP filters?
-
And more. When you create a virtual COM port via USB I nominate one of the ports on the CW keying. Periodically, the port stops working. I remove the connector from USB computer and back of his stick. After this keying appears. Then again disappears. I had to solder interface on the LPT port and send a signal to the connector I/O. What should I do to avoid problems with the USB ports?
-
I hope someone who uses the FT-5000 can answer. We do not have the radios. I have not heard about any problem like that before.
73 de mike
-
Leo,
make sure WIDTH is ON at the remote side for every band and mode
for some unknown reason this can not not be switched ON/OFF when it wasn't ON b4
Guy ON4AOI
-
Fine. I'll try. Function Contur also can not turn on remotely?
-
Yes Leo there are a few buttons that can not be turned
ON when they never were on b4 on remote rig
strange since afterwards you can switch on and off during a connection
Guy ON4AOI