Remote Rig

Webswitch 1216H Support in English => General discussion forum => Topic started by: Chris DL5NAM on 2012-06-11, 10:46:23

Title: any using V2.5 with success?
Post by: Chris DL5NAM on 2012-06-11, 10:46:23

Hello, i am using the V2.5 firmware and try to activate in Advanced settings a other function type. Can select a new function type but after Submit and Apply it shows always : Manual relay and temp reading

Also no chance to reach a antennas switch window.

Antenna selection window shows always: Not supported in this Function Type!

Missing a real manual, online help not real a help.

Any comment/help from Remoterig crew is welcome ( Teamviewer still runing :-)

Title: Re: any using V2.5 with success?
Post by: Jan (Microbit) on 2012-06-11, 12:11:49

Hi there,

If you have selected one of these rotators: Prosistel D, Green Heron, DCU1 or Yaesu GS232B then the UART/serial port is already in use and therefore it isn't possible to use other Function types which also use the UART. So what you see is most likely the program blocking combinations of features not supported. That will also make the Antenna selection page show "Not supported in this Function type".

What is a "real manual"? Not paper I suppose, hehe? A PDF maybe?

Title: Re: any using V2.5 with success?
Post by: Chris DL5NAM on 2012-06-11, 21:56:05

Jan, thanks for info.

And YES - a PDF will be fine. Actual online help is not real usefull and a liitle bit "hungry"  ;)


regards
Chris