Remote Rig

RRC 1258 Support in English => General discussion forum => Topic started by: OE1KBC on 2010-02-01, 23:50:08

Title: ICOM ID1 - 23cm, DV Transceiver
Post by: OE1KBC on 2010-02-01, 23:50:08

Hi all,
as my ICOM 2820 is working very well remotly, i´ve made a pair of cables to connect
my ICOM ID-1 remotly. I´ve used the same radio setting (9=2820).
But it does not work. It seems to have not the same protokoll or the same baud rate?
When i use radio type 1 = ICOM i can transfer audio with the same set of cables but
the RC-24 (controlunit) stay with no light and no display.

Any solution out there?

73 de Kurt
OE1KBC

Title: Re: ICOM ID1 - 23cm, DV Transceiver
Post by: sm2o on 2010-02-17, 20:20:34

Hi

Probably there are some differences in the communication protocols. Since there is no protocol documentation available we always need to have the radio in hand to check out the protocols manually. It can be very time consumming so it has to be rigs which are quite common if we should be payed back for the work.

73 de mike