Remote Rig
RRC 1258 Support in English => Configuration, RRC 1258 => Topic started by: IZ4MJP on 2012-11-13, 13:19:59
-
I've just completed the setup for working RTTY via FSK using a TS-480 SAT + RemoteRig MKII and MMYTTY.
All works fine but i've noticed that the "signal intensity" (the amplitude of the signal) on the MMTTY waterfall seems very low.
I can decode the strongest signals without problem but in presence of "normal signal level" MMTTY decodes very bad.
I've compared the same signals on two different PC/RTx (TS-480 + RRig + MMTTY and a FT-1000 MP Mark V Field + MicroKeyer II + MMTTY).
With the use of MicroKeyer (always using FSK and NOT AFSK) i can adjust the volume settings of the incoming signal.
I'm wondering if the same is possible with RRig and/or MMTTY.
Just another question: If i use a CODEC with more quality (now i use Codec 0 Alaw 8 Khz) could the signal improve?
Many thanks for any help/suggestions.
Vy 73
Franco, IZ4MJP