Remote Rig

RRC-Micro PC Client in English => General discussion => Topic started by: oe1tkw on 2013-03-26, 23:22:26

Title: CW speed does not change
Post by: oe1tkw on 2013-03-26, 23:22:26
HI
Has anyone else the same problem :
Thogh I want to change the CW speed, it does not change in fact.
I use settings, CW Speed, change it and store it by clicking ok.
it shows the changes value, when settings is called up again.
Then I connect again. 
However, the TX ( FT-2000) still sends in the same speed.
I reduce from 15 to 10 to 5 WPM, no effect, the Function Key ( F2 in my case) still sends with the same speed.

I can provide a Debug file.

Second, more general question: it is impractical to have to disconnect and re-connect to change the speed.
Why isn't this possible during the connection...?

73 es tnx
Helmut, OE1TKW
I run release 1.6.4 Beta.
 

Title: Re: CW speed does not change
Post by: roland on 2013-03-27, 08:29:38
Will have a look at that
Title: Re: CW speed does not change
Post by: roland on 2013-03-27, 10:45:40
It does not work until a program restart.
This will be fixed in 1.6.6

Thanks for bringing this to my attention
Roland
Title: Re: CW speed does not change
Post by: SM0HXB on 2013-03-27, 14:48:50
Hi Roland
I have not thought of this before, but to raise or lower cw-speed has no effect on my PC client either. I have version 1.6.5

/ Göran
Title: Re: CW speed does not change
Post by: roland on 2013-03-27, 14:51:03
Yes. The error is verified by me and fixed.
Fix will be included in next update.