Remote Rig
RRC 1258 Support in English => Configuration, RRC 1258 => Topic started by: VE3VEE on 2013-04-28, 21:31:52
-
TS-480
New RRC set
New user
Testing via home LAN (0 ms latency)
Playing a single dash results in transmitting three dots. If I want to send two dashes the TCVR sends 5 dots instead. Dots I can send just fine, it's only the dashes that it doesn't generate. However, I can hear my CW just fine from the TS-480 panel, but the TCVR transmits only dots, not a single dash. I first observed it as I attempted to make a test QSO. The station I called as "de ve3vee" answered: "h5hee" or something like that. That gave me the idea to monitor my transmitted signal with another RX.
I played with the delay settings, but that has no effect on anything as there's no latency issue here (testing just via home LAN).
I searched this forum, but it seems no-one has posted about this issue before.
73 de VE3VEE
-
SOLVED. It was my mistake. The Radio-RRC is supposed to be connected to the KEY-input of TS-480. I mistakenly connected to the PADDLE-input (which is located right beside the KEY-input). It will teach me a lesson to read the manual next time. But it was fun to operate as H5HEE instead of VE3VEE :-)
73 de VE3VEE