Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: Miles on 2013-09-15, 16:10:42
-
About working with the FT-857 the manual says:
“You must install a remote controlled switched so you can switch off the 13,8V power to the radio. For example a Webswitch 1216H, or a GSM Switch, If you do no use all outputs on the RRC-1258 you can use one of the outputs to control a relay which can switch off the 13.8V power to the Radio.”
Does anybody have experience with that last option (using an RRC output to switch the radio's psu off and on). I would be very much interested how people have done this.
Thanks and 73
Miles
PA3CVV
-
Hi Miles
you can do that via one of the I/O - you need to build a small relay system to support it
73 de
Ziv - 4Z4OQ
-
Hi Ziv,
Thanks! Wonder if you have some tips about the relay. What kind of voltage can the I/O of he RCC switch. Obviously not 230 :) What type of relay would be best to switch the power supply unit of the radio?
73
Miles
-
Hi
Sorry for late reply i was on business trip. I am using a small readrelay to control a 12v/15amp one
Ziv
-
quick question..
Can I connect from my PS a 12v relay (190ma coil current) to OUT0 open collector pin 5 for On/Off mode?
-
Yes you can
but do not forget the flyback diode over the relay coil
/mike
-
Sure.. thanks !