Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: OZ4ACK on 2014-10-03, 19:36:34
-
Hi i am the lucky owner of a rrc kit rrc 1258 mk ii s
My question is it possible to switch a linear amplifier on / off via either com 1 or com 2
It would be nice and do remote perfect for me
Regards Mogens oz4ack
-
Hi Mogens,
Basically you could use either port, but note the following:
- COM2 is normally used for CAT. If for some reason you don't want to run CAT, you can use COM2 for another device such as the amp.
- COM1 is wired differently from COM2 (essentially "backwards"). Look at the manual carefully for the pinout if you choose to use COM1.
73,
Mitch DJ0QN / K7DX
-
Hi Mitch thanks for info
73 mogens