Remote Rig
RRC 1258 Support in English => Configuration of Routers, Firewalls, etc => Topic started by: ve2jtx on 2015-01-08, 21:04:55
-
Do you need port forwarding?(router) on both site?
-
Only on the radio side (usually).
73,
Mitch DJ0QN / K7DX
-
THANK YOU 73'S
-
mY HEAD SEND ALWAYS 3 TONE .... NO CONNECTION .? WHAT PORT I NEED TO FOWARD
-
Hi
As the manual says, You need to forward port 80,13000,13001,13002
/mike
-
i foward this 3 ports, i read port sip 5060 ?
-
Drop me a short mail to dj0qn (at) darc.de and I will send you my networking checklist that walks you through the installation process.
73,
Mitch DJ0QN / K7DX
-
All works !
-
Mitch - could you drop me the same quick setup sheet? thanks and 73s.. bob W5RF
-
Sure, Bob, but I need your email address. Drop me a short mail at dj0qn ( at ) darc.de and I will send it to you.
73,
Mitch DJ0QN / K7DX
-
thanks! :)
-
Hi Mitch, I know it is an old thread but any chance getting a copy of you config help as well.
vk6ei (at) bigpond (dot) com
removing the obvious :-)
Thanks
Tim, VK6ei
I wish there was a beginners dummy guide, just bought the Micro PC setup but I admit it is beatin me so far..
-
Done!
73,
Mitch DJ0QN / K7DX