Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: K1UO - Larry on 2015-02-03, 01:58:30
-
How do I find what hostname was assigned to the 1258 units I purchased off another fellow? I want to register them at Microbit DDNS service.
-
Just turn the feature on under the menu called "Dynamic DNS settings" and it will pop up.
This is from page 66 in the manual:
To activate the Remoterig dynamic dns client select “ddns.remoterig.com” from the drop
down on the Dynamic DNS settings page. Also select a DNS check interval, if your IP address
change often you can select a low value, if it goes month between the changes you can select
a higher value. After that click on “Submit” and “Apply changes”, the RRC will restart.
Btw... It's only available in the Radio-RRC!
73 de Adde, SM0SHG
-
It is also explained on the checklist I sent you, Larry.
73,
Mitch DJ0QN / K7DX
-
Ok thanks guys, I made the "assumption" that since the serial numbered unit was registered by the previous owner at his remote router location that I would cause problems by initiating another registration of the same serial number.
BTW: everything is working fine so far with k3/0 to k3. Just need to get various peripherals connected and operational now. Waiting for the RPON unit to finish the RC-1216H connection to the Acom2000 amp. Thanks Mitch for your helpful information.
-
No, it goes to whatever network it is located in at that point in time.
73,
Mitch DJ0QN / K7DX