Remote Rig

RRC 1258 Support in English => General discussion forum => Topic started by: dl3jpn on 2015-02-26, 08:43:32

Title: AlfaSpid control box with USB and RC-1216H
Post by: dl3jpn on 2015-02-26, 08:43:32

Hi all,
In the new AlfaSpid Controllers, the RS232 connection have been replaced with a USB Connector.
How can I use it with a RC-1216H? I think normal USB2RS232-Adapters won't work. Has anyone
else used the same setup? Any suggestions?
Thanks in advance.

73, Steffen

Title: Re: AlfaSpid control box with USB and RC-1216H
Post by: sm2o on 2015-02-26, 08:46:22

No it will not work with USB, but I think you can order the rotator with RS-232 connector. At least it was possible last year

73 de mike

Title: Re: AlfaSpid control box with USB and RC-1216H
Post by: dl3jpn on 2015-02-26, 09:01:24

Mike,
I' ll try this with an other supplier. The one I asked has only USB-Versions.
Thanks for your very fast answer.
73, Steffen

Title: Re: AlfaSpid control box with USB and RC-1216H
Post by: g4swx on 2015-02-26, 22:41:55

Steffen writes: > In the new AlfaSpid Controllers, the RS232 connection have been replaced with a USB Connector.

This is really bad news as although I don't use RS232 tunnels over the RRC1258 I do use RS232 over Ethernet with Wiznet stand alone cards and virtual serial port software to remote many of my station components. I was considering the AlfaSpid BIG RAS for my next EME system.........
I have tried a number of USB over Ethernet, so called 'solutions' but all result in bursts of very high bandwidth traffic.

73
John G4SWX

Title: Re: AlfaSpid control box with USB and RC-1216H
Post by: sm2o on 2015-02-26, 23:13:29

Sad that they don't care about remote controlling. Have you checked how they have done the USB interface ? In many products where they have added a USB port instead of  a serial, they have put a USB to serial converter IC inside the box and have not made any change on the firmware. If this is the case for the AlfaSpid it may be possible to cut some traces and connect a MAX232 (TTL/RS232 converter) instead of the USB IC.

73 de mike

Title: Re: AlfaSpid control box with USB and RC-1216H
Post by: dl3jpn on 2015-02-27, 15:19:26

Hi John and Mike,

Good News. Today I got an info from a German supplier, stating that spid still builds controller with RS-232 interface. It is possible to get them on special request. Delivery time may be a bit expanded but they are still available.

73,
Steffen, DL3JPN

Title: Re: AlfaSpid control box with USB and RC-1216H
Post by: sm2o on 2016-09-14, 15:32:14

Hi I converted AlfaSpid with USB interface to RS-232. Here is some info about how i did. It's quite easy.

http://www.remoterig.com/wp/?page_id=3414 (http://www.remoterig.com/wp/?page_id=3414)

73 de mike