Remote Rig

Webswitch 1216H Support in English => Configuration, Webswitch 1216H => Topic started by: Kd5m on 2015-07-13, 04:02:36

Title: Antenna Selection Page
Post by: Kd5m on 2015-07-13, 04:02:36

I get an error message "Not supported in this Function Type!" when I select the antenna selection page. I have 1216H Webswitch software 4.17 Ham loaded. I do not see the extensive antenna selection page as shown in the help file. Is this my error or a software error?
Thanks for you help.
Edd - KD5M

Title: Re: Antenna Selection Page
Post by: Jan (Microbit) on 2015-07-13, 08:52:30

In order to use Antenna Selection you will have to enable it. That is done on the Advanced Settings page, setting 'Function Type'.

Title: Re: Antenna Selection Page
Post by: Kd5m on 2015-07-13, 13:30:19

Good morning Jan - thanks for your help. What is the correct "Function Type" to set on the advanced page? I see settings for ICOM, Kenwood, Yaesu, R&S, and some for heating/cooling control. Mine is currently set for "Manual relay and temp reading".
Edd - KD5M

Title: Re: Antenna Selection Page
Post by: Jan (Microbit) on 2015-07-13, 14:30:08

Depends on which radio you have  :)