Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: Serge_VA3SB on 2015-10-01, 15:45:56
-
Good morning to the group.
I just installed the WiFi module in my control unit. From the manual, I understand that I should be able to use the control unit by powering it through the USB port on my laptop. Unfortunately, when I connect the USB cable I am not able to connect. I see that the Green Power LED flashes instead of being on continuously. Please note, that at this point in time that I am trying to connect within my home network. I have obviously missed something. Any help would be appreciated.
Thank you in advance for your assistance.
73
Serge
VA3SB
-
Powering the RRC via USB is only for setting up IP-addresses etc. most of the RRC is not powered from USB so you must connect 12V when you really using it.
73 de mike
-
Thank yo for your prompt response Mike. I understand.
Regards
Serge
VA3SB