Remote Rig
RRC-Micro PC Client in English => General discussion => Topic started by: OH1MLZ on 2015-10-30, 09:01:37
-
Setup:
1. RRC-Micro v1.8.0.0
2. Hardware dongle 1274B
3. Operating system Windows 7 Enterprise SP1 64-bit
4. At remote site RRC-1258 MkII with FW version 2.86 and K3 radio
Steps to reproduce the problem:
1. Open RRC-Micro client
2. Set up this CW macro: CFMUR5NN5NNDEOH1MLZTU
3. Other CW settings: speed 35 WPM, delay 50, weight 30
4. Send the macro: it works normally and color coding of sent message turns from yellow to blue in syncronization with sent CW
5. Close RRC-Micro by hitting the red disconnect button but do not close the client
6. Wait for few seconds
7. Push connect to reconnect
8. Send the macro: what happens is that color coding of sent message turns from yellow to blue NOT in syncronization with sent CW, actually much faster AND sent CW message on air is: CFMUR5NN5NNDEO1Z
-
Thanks for the report.
Will have a look at that
-
Good to hear that. Looking forward for the new release. Could you also comment on feasibility of features from my wish list?
Juha
-
Version 1.9.2.0 tried and it has the same problem.
-
Version 1.9.2.0 tried and it has the same problem.
Radio RRC firmware version?
-
2.86
-
2.86
You could give 2.90 a try.
-
I have now updated to 2.90 but the same problem is still there.
-
New observation from today: when sending so much macros (like calling in pileup) that text screen below macro buttons becomes full, macros don't work properly anymore. Clearing text screen with clear button does not correct the problem and the client must be restarted. This is with version 1.9.2.0. All this restarting takes way too much time in a pileup.
-
This is still not solved..