Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: Km4eug on 2015-11-14, 18:25:11
-
I have set up, ip and all settings in the cut sheet for the ts480. all the remote head wil do is beep beep beep after I turn it on no display or such.
what am I missing?
Terry km4eug Tennessee
-
does any one reply? or do you just read? what other settings are required to make these work? do I have a defective unit? how do you confirm it works or does not ?
-
If the control head only says beep beep beep beep it could be that there is no commection to the radio rrc or missing internet connection, had that problem once the power was down at radio site
Regards oz4ack
-
What is the state of the LED's on the control RRC box after it has been turned on for a few minutes? This may give us a clue.
joe
-
I sent him my checklist to go through.
73,
Mitch DJ0QN / K7DX
-
lights are green, they are not on a network, on a cross over cable and i am removing sip password "hello" from both no luck thus far
-
What is the message on the status pages?
73,
Mitch DJ0QN / K7DX
-
I have it working on network. the wireless will not connect will the wireless work on a WPA2 encryption?
-
is there not a set of file I can load in and make these work?
I have made s many settings and try this try that and try try oh who knows what they are suppose to be ?
I had it working on local and then its not working at all flashing green and yellow lights