Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: KC7JLU on 2016-01-06, 15:27:23
-
I have the remote rig setup and It is simply amazing I bought a second unit for another remote location. The question I have is I am trying to program the radio with KRS-480 from the control side I have read other threads about problems with HRD and the Kenwood software but this is just programing the radio can this be done with the serial ports settings port 1 on the radio side is hooked up to the radio DB-9 ? Thanks again
-
Has anyone tried this?
-
I have not tried that excat combination ... but
I have hook up the serial port of the main unit to the radio RRC (DB9) via RRC Com2 mode 4 9600,8,1,N (same setting on com2 control site)
At control site im using a microHam (USB->Serial interface) to map to a serial port at my computer.
I can then start any program to communicate with the radio at the control site vis the cat interface.