Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: Serge_VA3SB on 2016-02-01, 03:21:03
-
Hello to the group.
I recently purchased a TS-490HX to use as my remote radio.
I had used my remoterig RRC's with a Yaesu FT 3K. Worked very well.
I made the changes to the jumpers as per the manual and when I press the "on" button on the radio, I am able to connect to the radio RRC (from within my own network. The problem is that I am not able to get the radio's control panel to illuminate. I am using a 5 amp power supply to power up the RRC COntrol unit. I have tested the RJ11 cables and they are working fine (if I connect them directly to the radio and control panel of the TS-480).
I have also changes the settings on both the Control unit and Radio RRC's as per the manual.
I would appreciate any information or feedback on this issues. Thank you very much for your assistance in advance.
Regards
Serge
VA3SB
-
Hi
You can send me ( as PM) the exported settings (html) files from both units so I can have a look at your settings.
73 de mike
-
Hi Mike. Thank you for your prompt response.
I will send you the HTML export files in a few minutes.
Thank you in advance.
73
Serge
VA3SB