Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: vk3ga on 2016-09-21, 06:54:27
-
Hi,
I have a K3-Twin setup with PC line-in and line-out connected to the Mini for digital modes.
When I choose CW or RTTY or PSK in Fldigi, the tx frequency is 600Hz higher than what the VFO is showing.
If I use the M1-M4 memories, no problem, the frequencies match.
Any ideas?
Thanks and 73, Graham VK3GA
-
Graham,
That looks like an Elecraft question, so I suggest you ask on their reflector at http://mailman.qth.net/mailman/listinfo/elecraft
instead.
From Googling a bit, it looks like you may have the VFO not set to mode DATA-A, but the memories are correct. However, you
should really ask the K3 and Fldigi users on that reflector.
73,
Mitch DJ0QN / K7DX