Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: w9ac on 2016-10-04, 14:04:01
-
I have N1MM+ set up as a client at home. It tunnels through the RRCs and communicates with an Elecraft K3 at the remote site. Using keyboard CW from N1MM is fine. But when I use paddles with N1MM running, CW is corrupt. Without N1MM, CW with paddles is fine.
Setup ideas?
Paul, W9AC
-
Hi Paul. I had a similar issue a couple of weeks ago.
In my case, the problem was that the KEY DELAY setting in my RRC CONTROL unit KEYER settings was at 0. I changed it to anything but 0 (try 25 or 50 ms) and the problem disappeared.
Give that a try and let us know. Good luck.
73
Serge
VA3SB
-
Hello everyone.
Sorry for the bandwidth but I neglected to indicate in my original response to W9AC that the reason I was able to solve my CW issue was due to a post by Max NG7M (http://www.remoterig.com/forum/index.php?topic=4902.0) who found the cw transmit problem and was good enough to post the solution.
73
Serge
VA3SB
-
Thanks for the suggestion, Serge. I double-checked the RRC Control unit. CW Delay (50 ms.) and LF Delay (100 ms.) appear to be fine.
Any other ideas are welcome.
Paul, W9AC