Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: NZ5E on 2010-12-27, 18:42:36
-
I am forwarding ports to the Remote Rig Radio Box, which is setup with a Static IP on my LAN. How can I also forward ports to my Webswitch and IP Camera if my router only has port forwarding to one IP?
-
Which router do you have?
-
Not aware of any router that can only forward to one IP adress in your network
maybe you should look under multipple ports forwarding in your router
Guy ON4AOI
-
Which router do you have?
I am using a Linksys WRT54G2 at the radio location.
I have a Linksys E1000 at my home that I could switch out if it offers some functionality that the other router does not.
-
Not aware of any router that can only forward to one IP adress in your network
maybe you should look under multipple ports forwarding in your router
Guy ON4AOI
I was traveling when I posted the question. I will look at the setup for each of my routers and see if port forwarding to multiple IP's is available in either one.
-
for wrt54g2, check under GAMING for multipple portforwarding
Guy ON4AOI
-
I use multiple devices to do port forwarding inside my network to multiple IP's. Each device either has a fixed IP, or uses DHCP, but is assigned a static IP by the router using its MAC address.
If you use an IP camera, either assign a fixed IP to it, or use the router's IP reservation feature via DHCP, then setup port forwarding to route from the external public IP/DNS to your internal private network. I use Netgear routers which has this feature, so do Trendnet. Limit DHCP IP range to not extend beyond fixed IP addresses.
My 2 Remoterigs use static fixed IP's and I assigned separate port numbers to each:
RemoteRig1 uses default ports:
RemoterigAudio 11000 192.168.0.228
RemoterigCmd 12000 192.168.0.228
RemoterigSIP 5060 192.168.0.228
RemoteRig2 uses next port number and different fixed IP:
RemoteRigAudio2 11001 192.168.0.230
RemoteRigCMD2 12001 192.168.0.230
RemoteRigSIP2 5061 192.168.0.230
-
When using multiple radios with multiples radio RRC's, how can you direct the connection from the control RRC to a specific radio, with a different forwarded port? Can you enter the port no. with the IP address in the addreees box?
-
I am forwarding ports to the Remote Rig Radio Box, which is setup with a Static IP on my LAN. How can I also forward ports to my Webswitch and IP Camera if my router only has port forwarding to one IP?
This article should guide you in setting the port forwarding on your Linksys router:
http://www.linksys.com/us/support-article?articleNum=136656
Charlie KB8CR