Remote Rig
RRC-Nano => General => Topic started by: OH6XE on 2017-07-24, 13:00:33
-
Last time panel works fine 2-3 weeks ago. And was not connected anywhere.
Now there is not 8 V voltage in 6 pole connector 2 and 3 pins.
Where should I try find problem.
When control panel is connected to TS-480 it works normally.
De OH6XE
-
Are you sure that the RRC is still configured for TS-480. 8V is only present on pin 2 if the RRC is set to a mode where it should be.
8V is switched on by the FET T5 (NTR1P02T1), I doubt it's broken, we have never got a RRC with broken T5
73 de mike
-
Radiosettings ts-480/TM-D710 etc
I have to Order fet I think, where it stand?
Put same packet with my wifi card what i ordered yesterday :D
-
this in wrong category, should be in RRC 1258
OH6XE