Remote Rig

RRC 1258 Support in English => General discussion forum => Topic started by: M0BPQ on 2017-10-31, 12:32:38

Title: Sequencing and CW
Post by: M0BPQ on 2017-10-31, 12:32:38
Hi Everyone,

I am using a TS-2000 with RRCs on VHF and up with preamps and a sequencer. I have broken the mic PTT line to drive the sequencer input. The system works great in SSB and digi, but I cannot use CW as the RRC winkey will not drive the sequencer. Any thoughts on how to do this?

I can rely on PC generated CW if required, so wondered about disabling vox and using the mic PTT to key the radio. If that is the case then I can't use N1MM to call CQ in CW without me keying the rig each time.

Thoughts/experience/anecdotes welcome.

Thanks!
Steve, M0BPQ