Remote Rig
RRC 1258 Support på Svenska => Konfiguration av RRC 1258 => Topic started by: DO8FJ on 2018-01-15, 19:17:06
-
Hello,
switching over to ddns from LAN I do not get any connection to my ICOM7100. It seems to be that everything is ok and my I-Net provider (same one on both sides - even router model) does support true IP adresses I cannot get connection to my Transceiver.
Status
Name Value
P5.4 OFF
Radio OFF
Connection status Disconnected
SIP status Unknown(1)
Last SIP error SIP Error
RTP/UDP audio status Disconnected
UDP cmd status Disconnected
SIP command timeout 3
Rx Jitter buffer size 4
Rx Jitter delay 3
Dual Rx 0
SIP Out port 13000
SIP In port 13000
Audio Out port 0
Audio In port 0
Command Out port 0
Command In port 13002
External SIP In port 13000
External Audio In port 13001
External Cmd In port 13002
Other party (IP Address)
Input 0 High
Input 1 High
Input 2 High
Output 0 Low
Output 1 Low
Output 2 Low
DNS status OK, xxxxxxx.ddns.remoterig.com = (IP Adress)
Active profile Default
PTT status OFF
Common network settings No
System messages No
The 1258MKII (Firmware 2.91.) was working fine on proper LAN connection.
HELP needed :D
Best regards,
Jens
-
Jens,
Did you forward the correct ports in your router and change the SIP contact to the external IP address
or DynamicDNS address?
73,
Mitch DJ0QN / K7DX
-
Hello Mitch,
do you have a description for that?
Best regards,
Jens
-
Hi Jens,
I guess that is a "nein". This is covered in the manual on pages 11 & 12, but I can send you
my networking checklist that walks you through the procedure if you want.
Du kannst mir eine kurze Mail an dj0qn (at) darc.de senden und ich kann die Checkliste an dich weiterleiten.
73,
Mitch DJ0QN / K7DX