Remote Rig
Webswitch 1216H Support in English => General discussion forum => Topic started by: Bob G3PJT on 2018-01-26, 15:59:33
-
Hi
Just configured RC 1216H to control a 2000A but the 1216 will not turn on the 2000A. ( that is the Power ON OFF button (page 44 of manual) makes a relay click but doesnt start the warm up sequence)
I can manually turn the amp on with the RCU and can then control and monitor the amp OK remotely, I can even turn it off! So that means the comms side is OK . The wiring connections seem OK too. But I cant turn the amp on to start the warm up sequence
I think this topic might have come up before but I cant find the post with the solution, or at least a few clues as to where to start looking :)
73 and thanks
Bob G3PJT