Remote Rig
Webswitch 1216H Support in English => Configuration, Webswitch 1216H => Topic started by: w5rhr on 2018-03-28, 18:42:11
-
I purchased two DS18B20 temp probes
https://www.ebay.com/itm/2pcs-DS18B20-Stainless-Steel-Waterproof-Digital-Thermal-Probe-Sensor-100cm/121952945265?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
and have tried to integrate them with my 1216H on BUSS B, since I have the rotor controller 1216L on buss A.
The probes are wired in the passive mode, VCC+ and - tied together to one connection of the 1216H and the data wire to the other.
Performing a scan results in the error message no Buss B 1 wire devices found
-
SO are the correct terminals those next to the Buss A connections?
I see terminals marked
Buss B
In -1
0 volts
In -2
-
Hi
temp sensors should be connected between BUS-A and 0V or BUS-B and 0 V
But we have seen that those Chinese sensors do not have a genuine Dallas sensor and the WS will not recognize some of them.
73 de mike
-
that is where I tried hooking them up, so must be the import problem.
I see the webstore has them, so I will order from there.
Thank you