Remote Rig

RRC 1258 Support in English => General discussion forum => Topic started by: w5rhr on 2018-07-30, 14:52:08

Title: RRC Control end stop connecting BUT Micro Client does
Post by: w5rhr on 2018-07-30, 14:52:08

For about a week now I have had issues getting my RRCs connected, and today it fails to connect to the radio end.

I have restarted both ends several times,
checked all settings
reloaded firmware on control end.

The web gui on the control end pops up so I am able to access the unit, also the saetup manager sees the unit,

the yellow SIP lamp is flashing on the control unit and the beep beep beep tone sounds when I press the " connect" button.

But now I can access my radio with the  trial software of RRC Micro client every time!!

Both units are on the same LAN, and I can swap network cables between the Control unit and the laptop the micro client is on and still; have the same issues.

Now finally after futzing with the control unit for the hundredth time it connected.

I don't know what else to troubleshoot

Title: Re: RRC Control end stop connecting BUT Micro Client does
Post by: sm2o on 2018-07-30, 17:48:23

if you got the conguestion tone you have set one or more parameters wrong. Check SIP contact, SIP password and the portnumbers

73 de mike

Title: Re: RRC Control end stop connecting BUT Micro Client does
Post by: w5rhr on 2018-07-31, 14:04:58

thank you for the reply, however those parameters are correct, they are the same as the radio end and the micro client end

Title: Re: RRC Control end stop connecting BUT Micro Client does
Post by: sm2o on 2018-07-31, 16:10:51

If the settings are correct it works, so something is set wrong. You can email me the exported settings(html) files from both units if you want me to take look.

73 de mike