Remote Rig
RRC 1258 Support in English => Hardware, Cabling, Installations => Topic started by: cx6vm on 2018-11-17, 01:40:36
-
hello
I have remoterig working properly with two K3/100 on both ends
Today I connected a footswitch to PTT IN on the back of K3/100, but no PTT, radio doesn´t go to TX
What else may I need to check to use footswitch?
thanks,
Jorge
CX6VM/CW5W
-
Hi
you cannot connect the footswitch to the K3 it has to be connected to Control-RRC I/O port IN0. And set IN0 to PTT
/mike
-
thanks Mike
so will need an adapter, RJ45 to connect to I/O on control RRC and RCA female to connect my footswitch
Is there a adapter for that? Or a diagram to see how to build one?
thanks,
-
Hi Jorge,
See page 232 of the manual for the schematic. All you need to do is to tale an old
network cable and cut-off one end. Take the two wires you need and solder them to
the RCA connector and you are finished in a few minutes.
73,
Mitch DJ0QN / K7DX
-
thanks very much Mitch
73,
Jorge
CX6VM/CW5W
-
thanks very much for the help.
I did the cable and working !
73,
Jorge
CX6VM/CW5W