Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: M0UOO on 2018-11-25, 20:04:53
-
Good evening Forum,
A good friend of mine has setup most of my remote rig to the extent that everything works on the radio side. The problem I am experiencing is that I am unable to operate the rotator through remote rig.
So, this is the configuration and equipment.
The remote station is an icom 7300 using the RRC-1258MkIIs (Standard version) connections are:
• SP to audit output from 7300
• AUX/Mic to mic plug on 7300
• TTL connected to the CI-V remote control jack
RRC-Micro PC-Client is on my laptop
We have been trying to use com1 to control the SPID RAU Azimuth Rotator using a parallel to USB connection from the 1258 to the rotator.
We achieve a com 1 light on the Microbit RRC Client page once we have configured the RCC Setting page under RRC COM 1
Mode – 5 User Defined
The 1258 shows no signs of receiving the signal I have tried HRD rotator and PstRotator AZ
Any help would be great fully received as this seems somewhat a difficult one for me.
Many thanks
Richard
M0UOO
-
Hi
You cannot use a USB rotator with Remoterig, Remoterig has no USB Host interface like a PC. Only a USB-Device Interface which cannot be connect to another USB-Device.
Here is more info about using Alfaspid, also info about how a USB alfaspid can be converted to a serial
http://www.remoterig.com/wp/?page_id=3458 (http://www.remoterig.com/wp/?page_id=3458)
73 de mike
-
Thank you Mike,
That explains it.. I will try and convert it as i have had the unit for a few years.
Many thanks
Richard
-
HI Mike,
Well managed to complete you mod many months ago and the SPID works fine on the local PC using the serial connection and through team view but this is somewhat clunky.
But when i plug the serial it into the 1258 unit it just doesn't see it.
I have COM 2 mode as:
Mode 5
baud rate 1200
data bit 8
stop bit 1
parity off
Terminator 00
I am, operation the IC 7300 through remote rig which works great are then any jumps i need to move for the rotator? or am i missing something really logically
Many thanks
Richard
M0UOO
-
use mode 1
/mike
-
Thanks Mike,
You are a complete star... works like a dream.
Another question do you known if you can operate the Icom RS-BA1 with remote rig or does it need to be completely separate?
I find HRD hard work to scan the bands and would like to see the waterfall on the 7300 and also a VFO whoich rotates.
Thanks again.
Richard
M0UOO :) :)
-
Yes you can use RS-BA1 via Remoterig, That's quite common. Just see the Remoterig as a extension of the serial cable.
73 de mike