Remote Rig
RRC 1258 Support på Svenska => Hårdvara, Kablage, Installationer => Topic started by: LA1RSA on 2019-01-17, 14:59:22
-
Hei,
Anyone that has the right I/O settings for TS-480 SAT
All works fine except from CW keying, it only sends a long tone whatever I'm keying.
Thanks/ LA1RSA
-
Here is my CW checklist for the TS-480:
CW Checklist
------------------------------
on the radio RRC:
- under keyer settings, set PTT activated by keyer to YES
- under I/O settings, change OUT2 mode to KEYER
on the control RRC:
- under keyer settings, set enable to YES
- change other keyer settings as desired
- under I/O settings, set IN0 mode to KEYER
Make sure that the cable is connected between the radio RRC and rig's key (NOT paddle) jack. If possible,
use a mono plug on the rig side, since stereo can cause problems under certain situations (e.g. FSK).
73,
Mitch DJ0QN / K7DX
-
Hei Mitch,
Thanks so much for your help, it solved the problem :)
73`LA1RSA / Frank