Remote Rig
Webswitch 1216H Support in English => General discussion forum => Topic started by: Cn8vy on 2019-05-14, 17:25:18
-
Hello,
Do you know a case of use of a remote rig set up by 2 operators located in different locations?
Actually, we are two friends living in 2 different cities. We want to set up a TRX in a farm and remote control the TRX from our respective qth.
We want to use omni antennas so there is no need to rotate aerials. 100W power only.
Thanks for your insights and advice
CN8VY
-
There are stations with many operators. I am on two with over 12.
You only need a means to have the two coordinate. Otherwise, the other op
will get a busy signal if the station is in use.
73,
Mitch DJ0QN / K7DX
-
Thanks Mitch
what is your configuration: radio front panel +RRC1258?
Kind regards
-
Correct, everyone has a TS-480 panel and RRC and/or a K3/0 and RRC. We have
both rigs running in both stations.
73,
Mitch DJ0QN / K7DX
-
That sounds amazing.
Thank you