Remote Rig
RRC 1258 Support in English => Configuration, RRC 1258 => Topic started by: VA2EBI on 2020-02-03, 19:39:34
-
I have used a RRC for a K3/0 connecting to RemoteHamRadio stations in the New York area. That was several years ago. I am now working to set up a pair of Yaesu FTdx-5000's in a Yaesu Twin remote network from my Control location in Massachusetts to the Radio location in Quebec. I purchased a new pair of RRC's and the Yaesu Twin accessory pack. I downloaded the Setup Manager and I'm looking at the DOS screen after connecting one of the new RRC's. My home network consists of a Linksys ACS router behind a Verizon router. The IP address of my PC is not the standard 192.168.1.xx. When I connected one of the new RRC's to my pc, the Autoconfig IPV4 address is quite different, and there is no Default Gateway. And I don't know the IP address of the network in Quebec that it will be connected to. At last, my question: how should I change the IP's of the new RRC's for the Control and Radio end of this planned remote network?
-
Drop me a short mail at dj0qn (at) darc (dot) de and I will send you my networking checklist
that walks you through the process.
73,
Mitch DJ0QN / K7DX
-
OK, thanks, Mitch.
George W1EBI