Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: N8CL on 2020-02-09, 17:56:09
-
About once a day, often at startup, I have no CAT: I can hear signals but frequency does not follow VFO. This is cured by removing power (power connector and USB cable) from the Control RRC and re-powering. The Radio side has no problems. Any ideas for a cure??
Thanks, Chuck, N8CL
-
Hi Chuck,
Your USB is going into power saving mode. Go to the following presentation at:
https://www.kkn.net/~n6tv/N6TV_Dayton_2019_Everything_USB.pdf
and follow the instructions starting on page 26.
73,
Mitch DJ0QN / K7DX
-
And here I thought I had checked the power settings many times--but I swapped out computers recently, and the new laptop had power save turned on. Thanks for your help, Mitch.
73, Chuck, N8CL