Remote Rig

RRC 1258 Support in English => Configuration, RRC 1258 => Topic started by: EA7TB on 2020-06-11, 16:49:41

Title: No conect on the local network
Post by: EA7TB on 2020-06-11, 16:49:41
Hi.
I am trying to connect the two RRC-1258 on the same local network.
But they don't connect.
I enclose the screenshots of the Status and info of the two modules.
The station he has is a TS-450.
Can you help me?
Regards.
Title: Re: No conect on the local network
Post by: dj0qn on 2020-06-11, 18:54:59
Unfortunately you posted the wrong pages. Important would have been the radio page.

What do do have as the SIP contact? When on the same network, this should be the
internal IP number and not the external IP number/DDNS address. A decent router will
recognize the "loop back" and block any attempt to use that address in your SIP contact.

Otherwise, let's see that page if this was correct.I am not aware that the TS-450 is a supported
radio. Most Kenwoods used are TS-480's.

73,
Mitch DJ0QN / K7DX

Title: Re: No conect on the local network
Post by: EA7TB on 2020-06-11, 19:35:48
Hi.
I have been confused it is a TS-480.
Attached are the radio setting screens
Regards.
Title: Re: No conect on the local network
Post by: dj0qn on 2020-06-11, 19:56:53
Yes, exactly the mistake I wrote about before. Correct it and it should work.

73,
Mitch DJ0QN / K7DX
Title: Re: No conect on the local network
Post by: EA7TB on 2020-06-11, 21:15:27
Hi.
Thank Mitch  .
Putting the ip that has an RF module, it works perfectly.
Regards.