Remote Rig

RRC-Micro PC Client in English => General discussion => Topic started by: fnord on 2011-04-20, 14:41:58

Title: Micophone Input
Post by: fnord on 2011-04-20, 14:41:58

I got a USB Condenser Mic, could i select the Condenser Mic from the List?
2nd.
If i got Virtual Audio Cable installed does it accept the Virtual Audio cable Input as input?
Example:
(MMSSTV-> (Virtual Audio Cable Output) --- >  (RRC Micro Software) --> (Virtual Audio Cable In))
2nd. PTT Keying

Is it possible to use VOX in this Programm so a noise gate dsp part in the program could also activate PTT?

Title: Re: Micophone Input
Post by: roland on 2011-04-20, 15:09:23

You can you any mic thats registered as a valid mic in Windows.
Same thing for speaker. Use any valid Windows speaker device thats listed.

NOTE. The Microbit 1274A audio device must be present as a Windows device
even if you use another mic and speaker.

Title: Re: Micophone Input
Post by: fnord on 2011-04-20, 22:28:59

i hope this stuff runs in a Virtual Environment under OSX (the USB Dongle may be a problem...)
And if that works, it should be possible to store the Microphone "wiring" setup in a preset, and select the preset in the Windows Tray or Keyboard shortcut...
e.g Switching from digital Mode chain to Microphone mode.