Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: Bart K8IRC on 2011-05-04, 03:20:28
-
I have the system working great on SSB but am having a problem with using the CONTROL unit internal keyer.
I get side tone and the keyer seems to work properly, but it does not key the radio.
If I turn the CONTROL keyer off, I can key the radio with one side of the paddle at the CONTROL.
The radio is connected from the PAD output on the RADIO unit to the KEY input of the TS-480
Any suggestions??
tnx
-
Hi
You have probably not select the output under the IO menu in the Radio-RRC
73 de mike
-
I tried to set OUT1 to keyer. and on/off to on. the button turns green
I hit Apply Changes
the RADIO RRC reboots
But when I check the IO settings it still shows OUT1 as OFF
It won't accept the change
???
Bart
-
On/off is not used when it set to keyer. You can try set both out1 and 2 to keyer to be sure
73 de mike
-
I set both OUT1 and OUT2 to Keyer.
Still will not key the transmitter.
Do I have to set any of the OUT parameters on the CONTROL??
I have everything set according to Page 63 of the manual except both OUT1 and OUT2 are set to Keyer on the RADIO RRC
-
Got it working
Thanks for your help
73