Remote Rig

RRC 1258 Support in English => General discussion forum => Topic started by: K8MV on 2011-06-21, 23:32:51

Title: Error Code 31 on Ver 2.35 while upgrading to 2.40
Post by: K8MV on 2011-06-21, 23:32:51
Just started setting up the Remoterig.  Followed instructions and tried to update to Ver 2.40 from 2.35.  Get error code 31.  any ideas
Title: Re: Error Code 31 on Ver 2.40
Post by: Jan (Microbit) on 2011-06-22, 09:54:47
You used Microbit Setup Manager? Could you give more details about what you did and where you got the error message? Also, did you simply get "error code 31"? Nothing else than that?
Title: Re: Error Code 31 on Ver 2.40
Post by: K8MV on 2011-06-22, 15:20:11
Yes using Microbit Setup Manager.  This is the initial setup.  Followed instructions to upgrade to newer version.  Am connected to the router wirelessly.  Both RCC units connected to the router.  Setup manager says RCC connected.  When trying to upgrade get the message:  Failed Program New Firmware Write Failed Error Code 31.  Should I continue with the setup and try to upgrade to the newer version later on?
Title: Re: Error Code 31 on Ver 2.40
Post by: Jan (Microbit) on 2011-06-22, 16:14:32
As you have version 2.35 you have a version with a fixed/known problem when attempting to update via USB. It was fixed in 2.36 as you can read about on http://www.remoterig.com/wp/?page_id=79 (http://www.remoterig.com/wp/?page_id=79). You will have to update via the web interface first, and then you will be able to use USB.
Title: Re: Error Code 31 on Ver 2.40
Post by: K8MV on 2011-06-22, 18:35:35
Thank You.  Upgrade is done, units are communicating via web, time to move on to setting up the rig.