Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: dj0qn on 2011-06-22, 19:12:43
-
I have a strange problem with the CW paddle connection:
I have three remote installations using RemoteRig and TS-480's that I currently manage.
In one of them, RemoteRig works just fine with a CW paddle cable plugged fully in the RRC's and TS-480's jacks.
In two of them, it does not. If you plug the cable about two-thirds of the way into the jack on the RRC,
then it works just fine. If you move it out a bit or push it all the way in, it doesn't work.
All three installations are identical, both in hardware and in RRC settings.
Anyone have a clue why this would be the case? It is not a "killer" problem, but it would be nice to solve this mystery.
73,
Mitch DJ0QN / K7DX