Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: PA5M on 2009-11-03, 13:31:32
-
When I was testing my FT-857 with HRD and also with Supercontrol.
I found that the display reading in both programs is unstable.
Most of the time the reading was incorrect with a lot of "b7C#" bla bla.
The TX/RX function in Supercontrol was also tested at the same time and it worked without problems.
I changed the baudrate settings, etc, in both the interfaces and the programs, but without luck.
Good to mention that I was doing those tests on my internal (1GB) network, so no delays occurred.
Has anyone got ideas how to get a proper corresponding display ?
73e Michael
PA5M