Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Ed

Pages: [1]
1
Both N1MM and DX4WIN allow me to use the virtual COM 1 port In my case the RRC created COM 5. DX Lab will not allow me to to use a single COM port for two different operations. Just  says Port i Use, can not open. Anyone having success?

2
General discussion forum / Re: Frozen Display on K3
« on: 2013-04-21, 15:02:06 »
I see the following when this happens to me:

Data Abort at 0x0004301c, called by 0x000436b4

    Newbie
    *
    Posts: 2
    Remote Station used with RemoteRig
        View Profile
        Email
        Personal Message (Offline)

Frozen Display on K3
« on: 2013-03-25, 18:58:05 »

    Quote

When I try and connect sometimes the display on the control K3 is frozen.  Yet, I can tune the radio, change bands, etc.
Any idea why this might be happening.  Using the newest software, and a K3 controlling a K3 rig.  73 and thanks,  Hank K9LZJ
Report to moderator   Logged
Hank Wolfla - K9LZJ
WW2DX (Lee)

    Jr. Member
    **
    Posts: 42
        AOL Instant Messenger - ljimber
        View Profile
        Personal Message (Offline)

Re: Frozen Display on K3
« Reply #1 on: 2013-03-27, 03:42:11 »

    Quote

Hi Hank,

When this happens what does the status page show on the RRC page? Do you see any failure messages in the status fields?

I suspect maybe one of the routers is having issues passing the control data stream. Do you have both routes setup to have the RRC's on the DMZ?

73 Lee
WW2DX

Pages: [1]