Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - VK3EQ

Pages: [1]
1
General discussion forum / Re: Selecting WiFi networks
« on: 2012-12-22, 22:59:30 »
Thank you for your reply Mike

I actually have more than one WiFi network running concurrently and I have observered that, according to the RRC, the signal strengths vary, with not always the nominated network being the strongest, hence the reason for my question.

At the moment I turn off all WiFi networks apart from the one I want to use, then make my connection. I normally have two operating, one with access to the internet and one without. In the future I could invisage some other network, not associated with me, causing problems. Hence, I would suggest the design choice of the choosing strongest WiFi signal is worthy of reevaluation.

From my perspective it would be really good to be able to nominate the specific WiFi network, if that is practical in the foreseeable future.

Thank you for you comment on the limitation of the WiFi chip

Rik

2
General discussion forum / Selecting WiFi networks
« on: 2012-12-22, 00:09:59 »
Hi All

I would like to be able to nominate a particular WiFi network for connection, without having to delete all the other networks from the WiFi list, and without always going to the strongest network - is this possible, or are there planned changes to the software to allow this to occur

Also, I would like to be able to connect Radio and Control directly by WiFi without the need of a router - I understand there has been some discussion on this topic previously - I only want to go a few hundred meters LOS

Feedback would be appreciated

Rik VK3KAN

3
Mike

Unfortunately I have an ISP problem at the mement, could you please send the details to the alternate email I sent to you. Also are the details somewhere on the web site or in the forum. It might be helpful for others to be able to resolve this issue

Rik VK3KAN

4
Has anyone experienced a problem with the RRC radio I/F resetting to the Controller IP address (192.168.0.227) after a master reset (held down for 30sec) and then being seen by the setup program as a controller not a radio. Have the same problem with my two RRC Radio I/Fs. I have the latest version of SW loaded on all I/Fs

Rik VK3KAN

5
General discussion / Re: RRC client 1.6.0
« on: 2012-11-17, 05:12:23 »
Has anyone had an issue with the colors - I have a problem with the Blue on Grey - the Blue is very difficult to impossible to read without getting up very close - is there a way to change colors

Rik

6
Configuration, RRC 1258 / Re: Ports not Open
« on: 2012-08-24, 04:44:04 »
Mitch

I am also having port set up issues, could you also please send me a copy of your notes

thanks in anticipation

Rik VK3KAN

Pages: [1]