Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - VE9HF

Pages: [1]
1
When setting up port forwarding on the radio end router do I put the IP address of the Radio RRC? In my case 192.168.0.15? Do I need to add any port number or just that address? Rick VE9HF

2
Hardware, Cabling, Installations / Re: TS-480 cables
« on: 2014-12-17, 23:12:06 »
The front panel is powered up with the RJ11 cable plugged into the radio. When I move the RJ11 from the radio to the RRC-1258 Control, the front panel won't power up. Any idea what I need to do? Rick VE9HF

3
Configuration, RRC 1258 / Setup Help Requested
« on: 2014-12-16, 22:55:37 »
I have two new RRC-1258 MkII boxes from HRO. Both are powered up and both are connected by ethernet cables to my router. I changed the IP addresses to 227 and 228 as per the manual, but both said they were "NOT REACHABLE" after they rebooted. I then noticed that the numbers for Gateway and DNS had "2" instead of "1" for the third number. I went back and changed the third number in IP address from "1" to "2" for both and that seemed to fix it. However, when I click on BROWSE I get the message "Unhandled exception has occurred in your application" and I can't get any further. Any assistance would be greatly appreciated. Rick VE9HF

Pages: [1]