Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - kl9a

Pages: [1]
1
Yes, I have tried a real 12V supply and also the included wall warts.

2
This is my 3rd RRC-1258MkII with this issue.

USB power works just fine.  I can see the device via COM1.  I get this error:
"Running on USB power, skipping ethernet init."

The 12V power in the back is not being seen.  Currently *two* units are not working.  Both were unplugged for a few months and I just plugged them back in.

I tried pushing the reset button and resetting them that way and I still get the same problem. 

12V source confirmed OK.

Any ideas on what I can check, or anything else to try?  Seems odd that I have had this problem multiple times!
Would really like to be going for WPX CW this coming weekend...

Thanks,
Chris KL9A

3
Hardware, Cabling, Installations / Re: Radio RRC: No Power
« on: 2017-08-07, 02:04:00 »
I am having a similar problem, except I get 13.5V everywhere I test.

Any other spots I should be checking other than what is shown in this thread?

Thanks,
Chris KL9A

4
Configuration, RRC 1258 / Windows 10 and Win-Test
« on: 2015-12-04, 21:40:24 »
I am running a new Windows 10 computer with RR Box and K3/0. 
Everything works 100% between N1MM+ and the RR Box.
I can't get Win-Test to see the radio at all.  I can *send* frequency commands OK and the K3/0 will accept those.

Same setup under Windows 8.1 on a different computer all work 100% in Win-Test and N1MM+.

I tried reinstalling everything, including drivers.
Anyone else had problems with Windows 10 and Win-Test?
The Win-Test guys say it is a RR Box and/or Windows issue.
Any help would be much appreciated!
Thanks,
Chris KL9A

Pages: [1]