Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - W7HLR

Pages: [1]
1
When using the RRCs with an all Elecraft system (K3S, P3, KAT500, KPA500), the accessory connector on the KPA500 is already in use.  Is there some other way to configure the 1216h so that I can monitor power and control operate/standby remotely?  I'm using a k30/mini on the control side.

2
General discussion forum / Re: Vox with Icom IC-7100
« on: 2018-01-16, 02:23:44 »
Thank you, Mitch!  Works fine now.

3
General discussion forum / Vox with Icom IC-7100
« on: 2018-01-14, 04:38:58 »
Vox does not work when the IC-7100 is in the remote control configuration, but is fine when directly connected to the base rig.  Is Vox supported via remote?  Is so, how do I configure?

Pages: [1]