Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - M1AQO

Pages: [1]
1
Good afternoon All,
I'm a frustrated Flex SmartSDR customer trying to use their remote system but cannot resolve the audio drop outs on SSB.
I am looking at the RemoteRig solution and I thought it best to ask advice before I buy in order not to be in the same position as the Flex.
Broadband speed at the remote site is 70mb down and 25mb up.  At the operating site 25mb down and 5mb up.  Using Cat6 cable to a 1gig switch direct from the router at the remote site and a cat6 cable straight out of the router to currently the Flex.
My knowledge is limited so excuse the question but would it be fair to say that there would be less data for the network to cope with, with say a 480 and the remote rig setup compared to my Flex6300 SDR.  My main mode is CW so any suggestion on a rig to give me an internal keyer with my paddle and the use of my straight key would be appreciated.
Thanks
Glenn
M1AQO

2
I tried,

I changed the port in the 1216h software from 80 because it's being used.  When I change it I cannot gain access to the unit from its local IP address.

When changed back yo 80 all is okay.

Tried to port forward but clearly don't understand enough about it.

Thanks

Glenn




3
Hi Mitch, did you receive my email ?  If not its glennnutsey@btinternet.com.

Thanks

Glenn

4
Hi
I am a new user and I am running a ts480 through my BT home internet along with a 1216h for my Prosistel rotator control.

I am trying to configure the 1216h so I can access the unit via the web remotely and I have generated the host name and username and then copied the own host name in to the web browser but it will not find the unit.

Any suggestions please ?

Thanks

Glenn

Pages: [1]