Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - F1RAF

Pages: [1]
1
That link given above is a bit pricey (50 ), don't you have any cheaper humidity sensor reference that has compatibility with the Webswitch?

Regards Nicolas F1RAF

2
I have a G-2800 DXC connected to RC1216 via an ERC4 serial interface. I have made the rotator calibration in the ERC interface (a software is provided by ERC) , not in RC1216 which just send RS232 to ethernet and manage 2 relays... I do not know the G232S-b device, but it should be able to calibrate your rotator.

73 Nicolas F1RAF

3
Hi there,

I have been using successfully the 1.3K (last firmware october 2017) remote control with RC-1216H (firmware 4.27) displaying on a webpage. This is quite easy to use, works very well but does not permit all functions such as the ATU control. To be able to use the "Tune" function, I have set the SPE software (kterm) and followed the remote ring instruction to create a serial port. Eventually it work, when I connect, the web windows of remote rig displays "remoted" and I have 2 windows from kterm software (one that displays power and SWR, the other one for functions (including "Tune"). The problem I am facing is that that software is very slow, when I hit a function, I have to wait for 2 minutes before it is confirmed by display. I initially had set the connexion at max speed (115.000). I tried at other speed, ands it does not change anything. Is it a known bug ? This is not an internet issue since all other remote devices (transceiver, rotator aso work very well, including SPE 1.3K when I use the remote rig window). Is it a known issue, what can be done? I have the last version of all firmwares and SPE software. My windows OS is Windows 7.

Pages: [1]