Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - IZ3ENH

Pages: [1]
1
General discussion forum / PC Client connect but do not work
« on: 2010-08-17, 22:49:58 »
Hi from Italy.
Just received the PC Client and I try to install on my portable.
All ok, also the connection showing "connected to sip:xxxx" and the led ok (left gray and right orange).
But...... no audio in and no ptt/audio out and also the HRD do not connect the radio.
I see, connecting the remote RRC via browser, that on "Status" the "Audio Out Port" is set to 0 (zero); normally when I connect with the RRC is set with the same number of audio in port, that I use 11060.
I use an ICOM IC706MKIIG, that works very well with RRCs, with the configuration "Radio settings" --> program mode --> 2-IC706 .
On the PC Client do not exist IC706 but only 2-ICOM CI-V and I use this setting.
I this something is wrong..... I also tryed ICOM CI-V on both ends, but nothing.
Thansk for help,
Stefano
IZ3ENH

2
General discussion forum / Relay connection to I/O port
« on: 2010-08-08, 11:33:52 »
Hi.
I do not exactly understand how I can connect a relay on the I/O remote port.
I se that I must configure the I/O port on the remote side as On/Off, for axemple using OUT0....
I seE n. 5 on I/O port... but what I connect there ??? The - ??? and the + 12 V????
I ask before make some mistake and cause some trouble on the RRC!
Thanks for the help,
Stefano
IZ3ENH

3
General discussion forum / 1216H dead ???
« on: 2010-08-07, 19:54:10 »
Hi from Italy.
I have configured the web switch properly and then mounted on its place (it must deconnect the antennas when radio is not in use).
Then I reconnected the device, before installing on thd site and the computer do not recognize the device via USB
I checked some other PC and the same, do not recognize the USB device........ and also via ethernet nothing!
What appens ???
Is there a reset to try??
Only life is the green led at the side of micro usb connector blinking......
Thanks,
Stefano IZ3ENH

4
General discussion forum / 706 modulation trouble
« on: 2010-07-03, 00:08:58 »
Hi from Italy.
After long time of test from my home (radio) to my office (control), I ended the remote site and started with same configuration, but from home (control) to remote site (radio).
The remote site is connected to internet via a Mikrotik LAN, that work very well.
The problem:
all is working, but there is NO modulation when transmitting. The rx is ok.
I tryed also to change the UDP audio port (now is 11060) and setting to 0 the audio quality for low bandwith, but nothing.
All is working, also with a very little delay, but no modulation out.
What you think????
Thanks for the help,
Stefano
IZ3ENH

Pages: [1]